Advance Tile Adhesive

We provide high-quality AAC blocks, adhesives, and construction solutions, ensuring durable, efficient, and innovative results for modern building projects.

Advance Tile Adhesive:-

Polymer fibre modified cement based adhesive with no vertical slip, suitable for fixing ceramic and Vitrified tiles for floors and walls in internal applications.

Characteristics:

Package: 20Kg
Color: Grey
C2 T compliant with EN 12004 standard
Type 2 T as per IS 15477-2019
For ceramic and Vitrified tiles
No vertical slip
Application up to 10 mm
Prolonged workability
Adjustable
Excellent workability

Usage Guide

Adronix Advance is a tile adhesive certified as C2 T (according to EN 12004) and Type 2 T (as per IS15477-2019) designed for Vitrified tiles and ceramic tiles (glazed, terra cotta)

Indoor Use:

On horizontal and vertical surfaces
On Cement and cement-lime plaster, cement screeds, cement ground coats and concrete

SUBSTRATE PREPARATION

Adhesive can be applied on even and compact substrates, free of any substances that reduce adherence (grease, bitumen, oil, paint, dust etc.). Concrete should be at least 1 month old. Cement screeds and plasters should be fully cured. Anhydrite (residual moisture below 0.5%) substrates should be mechanically roughened and cleaned from dust. Aerated concrete should be free from dust. Substrates must not be wet. Any existing dirt, loose layers and paint coating shall be mechanically removed. Absorbent substrates shall be dampen and remove excess water before application.

APPLICATION

Pour Adronix Advance Tile Adhesive into a container with the precisely measured amount of clean water and stir with a drill and mixer until a homogeneous mass without lumps is obtained. Leave for 5 min. and then stir again. Apply the mortar with a suitable notched trowel. Use the proper sized notch trowel to ensure full bedding in the tile. Do not soak tile adhesive in the water. The back buttering method shall be used for larger tiles and for outdoor applications (i.e., additionally a thin layer of the mortar should be spread on the tile’s back side, contact area > 90%). Place the tiles only during the open time of the adhesive. Fresh excess mortar can be removed with water, hardened material can only be removed mechanically. Grouting on the wall can be done after 8 hrs in (Gres tiles) and after 24 hrs in porous tiles using Adronix grouts. Floors are set to light traffic after approx. 24 hrs. Expansion joints, joints at the corners of walls and floor, and around sanitary equipment shall be filled with sealants or shall be treated with appropriate treatment.

Products

Quick Inquiry

GKV AAC Pvt. Ltd. offers premium AAC blocks, block joining mortar, ready-mix plaster, and tile adhesives designed to deliver superior durability, enhance structural strength, and ensure long-lasting performance.